Last updated on December 16th, 2023 at 04:01 am
Upon the Chimney Snow Angel
by Rebekah Meier
Wouldn’t this cute snowman look great upon your fireplace mantel or entry table?
Typical Project Completion Time: 2 hours
Materials Needed
STYROFOAM®Brand Foam:
Balls, one each: 3″; 2″
Sculpturing Block, 18″ x 4″ x 4″
Other Materials:
Acrylic paints: black; orange; metallic silver
Paint for STYROFOAM, white
Paper: Christmas carol sheet music; white card stock, 8-1/2″ x 11″, two sheets
Cream felt, 9″ x 12″ sheet
Silver chenille stem
White/iridescent glitter: ultra-fine; fine
White feather angel wings, 3-1/2″ tall, one pair
Allspice balls or small beads, two
Powdered blush
Serrated knife
Candle stub or paraffin
Pencil
Ruler
Round wooden toothpicks, three
Medium flat paintbrush
Disposable palette
Water basin
Paper towels
Scissors
Low-temp glue gun and glue sticks
Thick, white craft glue
Photocopier
Optional: Large rubber bands
Project Instructions
1. Wax serrated knife with candle stub or paraffin and cut foam block to 7″ tall; set aside larger piece for future project. Cut 3/4″-thick slice from bottom of 3″ foam ball. (Note: If Sculpting Block is not available, purchase smaller sizes of blocks and glue together. Once glue is dried, trim block to 7″ x 4″ x 4″.)
2. Glue end of one toothpick halfway into bottom of 3″ ball. Apply glue to flat side of ball and glue other end of toothpick into center top of block. In same way, glue 2″ foam ball to top of 3″ ball, forming snowman.
3. Photocopy sheet music onto both card stock sheets; trim to 7″ x 8-1/2″. Wrap and glue card stock around sides of foam block, overlapping ends slightly. Note: Place large rubber bands around block to secure paper until glue dries.
4. Follow manufacturer’s instructions to apply foam paint to snowman and top of chimney, letting paint run down sides to resemble snow. While wet, sprinkle paint with fine, then ultra-fine, glitter. Let dry completely.
5. For hat crown, cut 2″ x 8″ piece from felt and tightly roll into 2″-tall cylinder; glue end to secure. Trace one end of crown onto felt twice; cut out one circle on line and one circle 3/8″ beyond line. Glue top and brim to crown; glue hat to head. Cut 3″ length from chenille stem and wrap around hat just above brim.
6. Paint allspice balls silver and let dry; glue to front of snowman’s body for buttons. For nose, paint one end of remaining toothpick orange; let dry. Cut tip from toothpick and glue to face.
7. Cut 3/4″ x 8″ scarf from felt and tie around snowman’s neck; spot glue to secure. Glue wings to back of body.
8. Cut remaining chenille stem in half; bend one end of each piece into small loop for hands. Glue and insert straight stem ends into sides of snowman.
Dip pencil tip into black paint and dot eyes; repeat to make five dots for mouth. Use fingertip to apply blush to cheeks.
Leave a Reply